Instructions for loading 800' Aaton XTR Prod film magazines
(Click any image to enlarge)

FEED SIDE

	1	Open doors and remove platter
	2	Place film on feed spindle (A). Film rolls off to form a nine ("9").
	3	Wrap film under roller.
	4	Feed film into coax roller
	5	Push several inches of film into coax roller, just enough film to enter take-up side. Film should push through easily. If it does not, pull out and re-insert.
	6	Replace platter on spindle, taking care not to catch platter under roller (B).

YES
NO

	1	Remove platter from take-up spindle.
	2	Pull 2 to 3 feet of stock out of coax roller (A).
	3	Thread film under top roller (B) and under top sprocket drive (C).
	4	Swing away each pinch roller arm (D) by depressing silver button. Arm will swing away from sprocket.
	5	Secure perfs into sprocket drive and swing pinch roller arm back into position. An audible click will be heard when arm is locked in place.
	6	Wrap film over top of bottom sprocket drive (E). Pinch roller arm must click into place, as in step 5.
	7	Form a 15 perf loop (H). Perf measurement is determined by the number of perfs visible in nose when take-up doors are closed.

8	Wrap film under bottom roller (F).
9	Remaining film should be wrapped counter-clockwise, emulsion side in on a 3 inch core.
NOTE: Only 3 inch cores can be used on take-up side!
10	Any slack in take-up side can be eliminated by gently holding bottom platter and turning the take-up core counter-clockwise.
11	Place platter back onto spindle, taking care to not hook platter under roller (F). See diagrams from feed side.